voltage 200 volts current 12 ampere maximum ra tings and electrical characteristics ratings at 25 o c ambient temperature unless otherwise specified. resistive or inductive load. SPAC1203F m a x i m u m r a t ings (@ t a =25 o c unless otherwise noted) electrical characteristics (@t a =25 o c unless otherwise noted) fea tures * low leakage * low forward voltage drop * high current capability * high surge capability * high reliability mechanical da t a * case: slim paq * epoxy: device has ul flammability classification 94v-o * lead: mil-std-202e method 208c guaranteed * mounting position: any r a tings maximum recurrent peak reverse voltage maximum rms voltage maximum dc blocking voltage maximum average forward rectified current at t c = 125 o c peak forward surge current 8.3 ms single half sine-wave superimposed on rated load (jedec method) typical thermal resistance (note 1) typical junction capacitance (note 2) symbol v rrm v dc i fsm c j t j , t stg v rms units volts volts amps 12 125 4.1 8.3 1.6 40 amps 0 c/ w 0 c operating a nd storage t e mperature ra n g e r q jc r q ja r q jl i o -55 to + 175 pf volts 200 SPAC1203F 200 140 2010-05 rev: b characteristics at rated dc blocking voltage v f symbol i r mamps maximum dc reverse current maximum instantaneous forward voltage at 12 a dc volts 10 @t a = 100 o c @t a = 25 o c 1.1 100 units SPAC1203F notes : 1 . thermal resistance : heat-sink case mounted or if pcb mounted. 2. measured at 1 mhz and applied reverse voltage of 4.0 volts. 3. "fully rohs compliant", "100% sn plating (pb-free)". 4. suffix "r" for reverse polarity. dimensions in inches and (millimeters) typical current square time i 2 t a 2 s 64.8 glass passivated silicon rectifier slimpaq .492 ( 12.5 ) .452 ( 11.5 ) .037 ( 0.95 ) .043 ( 1.10 ) .492 ( 12.5 ) .452 ( 11.5 ) .006 ( 0.15 ) .010 ( 0.25 ) .260 ( 6.60 ) .280 ( 7.11 ) .220 ( 5.59 ) .245 ( 6.22 ) .138 ( 3.5 ) .098 ( 2.5 ) 1.25mm(max.) 5. available in halogen-free epoxy by adding suffix -hf after the part nbr.
instantaneous forward voltage, (v) percent rated peak reverse voltage, (%) instantaneous forward current, (a) case temperature, ( o c) 0 0.1 0.4 1.0 4 40 20 10 average forward current, (a) c t , junction capacitance, (pf) 0 5 10 15 25 20 2.0 1.5 0.5 1.0 3.0 2.5 3.5 200 175 150 100 50 0 20 1.0 0.1 10 100 1000 120 100 40 60 80 140 rating and characteristics curves ( SPAC1203F ) fig.3 typical reverse characteristics fig.1 typical forward current derating curve fig.2 typical instantaneous forward characteristics reverse voltage, (v) instantaneous reverse current, (ma) 0.1 0.2 0 2 4 6 60 40 20 10 100 200 40 100 0.4 1.0 2 4 10 20 fig.4 typical junction capacitance number of cycles at 60hz peak forward surge current, (a) 1 0 75 100 125 25 50 150 5 2 10 20 50 100 fig.5 maximum non-repetitive forward surge current single phase half wave 60 hz inductive or resistive load t a = 100 o c t a = 25 o c 8.3ms single half sine-wave jedec method t a = 25 o c pulse width = 300ms 1% duty cycle t j = 25 o c d.c with heat sink
rectron inc reserves the right to make changes without notice to any product specification herein, to make corrections, modifications, enhancements or other changes. rectron inc or anyone on its behalf assumes no responsibility or liabi- lity for any errors or inaccuracies. data sheet specifications and its information contained are intended to provide a product description only. "typical" paramet- ers which may be included on rectron data sheets and/ or specifications ca- n and do vary in different applications and actual performance may vary over ti- me. rectron inc does not assume any liability arising out of the application or use of any product or circuit. rectron products are not designed, intended or authorized for use in medical, life-saving implant or other applications intended for life-sustaining or other rela- ted applications where a failure or malfunction of component or circuitry may di- rectly or indirectly cause injury or threaten a life without expressed written appr- oval of rectron inc. customers using or selling rectron components for use in such applications do so at their own risk and shall agree to fully indemnify rect- ron inc and its subsidiaries harmless against all claims, damages and expendit- ures. disclaimer notice
|
